| Function | Location (Example) | Value Range | Description | | :--- | :--- | :--- | :--- | | Entry Time | 10 | 01-99 seconds | Delay before alarm after entering through entry/exit zone | | Exit Time | 11 | 01-99 seconds | Time to leave after arming | | Bell Cut-off | 12 | 01-30 minutes | Max siren run time | | Dialer Attempts | 20 | 01-15 | Number of phone number retries | | Reporting Format | 21 | 1=Contact ID, 2=4+2 | Communication protocol | | Monitoring Phone 1 | 30 | Up to 16 digits | Central station receiver number | | PGM Event Type | 50 | 00-15 | What triggers the PGM output |
This is a transistorized output (low current, ~50mA) that can be configured as: mcm logicom 8 installer manual
To enter Programming Mode, press [*] + [8] + [Installer Code] (Factory Default: ). Common Program Addresses | Function | Location (Example) | Value Range
Power the panel up while holding any button on the keypad for 3 seconds . 3. Programming the Logicom 8 Programming the Logicom 8 Before diving into the
Before diving into the installer manual, let’s inventory the hardware. The Logicom 8 typically includes:
Note: Actual locations vary by firmware revision. Consult your specific manual page 22–35.
The MCM Logicom 8 system has specific technical specifications that must be considered during installation and configuration. Some of the key technical specifications include: