Dixell Xw60ls Manual Jun 2026

| Code | Description | Probable Cause | Action | |------|-------------|----------------|--------| | | Room probe error (open/short) | Faulty NTC/PTC probe or wiring | Check probe resistance (NTC: ~10KΩ @25°C) | | P2 | Evaporator probe error | Second probe missing or failed | Disable probe or replace | | HA | High temperature alarm | Setpoint too high, refrigerant leak, door left open | Check refrigeration system | | LA | Low temperature alarm | Setpoint too low, probe error, blocked airflow | Verify setpoint and evaporator fan | | dA | Door open alarm | Door left open beyond doA time | Close door or check door switch | | EAL | External alarm triggered | Digital input closed (if EAL mode) | Check external safety device | | EE | EEPROM failure | Internal memory corruption | Replace controller (requires reconfiguration) |

Refer to Emerson/Copeland’s official XW60LS – ISTR 03/11 installation manual or contact technical support with the controller’s full model code and firmware version (visible during power-up). dixell xw60ls manual

A: Change parameter FSt (Fan Stop temp) to a value higher than the defrost termination temperature. Typically, set FSt to 30°C so the fan only runs if the coil is cold. | Code | Description | Probable Cause |

The XW60LS features a front membrane keypad with 4 buttons and a 3-digit display. Below is the terminal block assignment (typical for XW60LS): The XW60LS features a front membrane keypad with

For : | Parameter | Value | |-----------|-------| | Set | -18°C | | Hy | 2°C | | LS | -30°C | | US | -10°C | | dtE | 15°C | | MdF | 30 minutes | | idF | 8 hours |

Inside Pr2, you can change:

This guide is for informational purposes. Always follow local electrical codes and the official Dixell XW60LS manual for your specific unit. Misconfiguration can lead to equipment damage or product loss.