Many homeowners make the mistake of tossing the manual aside after installation. This leads to inefficiency, premature system failure, and poor water quality. A typical Nova Water Softener Manual provides:
The drive motor cannot turn the cam. Solution: Unplug unit for 30 seconds. Remove motor cover and manually rotate the cam with pliers (see Figure 12 in manual). If still stuck, replace motor.
Press and hold the REGEN button for 3 seconds. The system will begin regeneration at the preset time (or immediately if pressed again). The manual warns: “Only force regen if salt level is adequate and no water is in use.” nova water softener manual
Keep the brine tank at least 1/3 full of pure water softener salt.
Most modern Novo units use a digital control valve that requires basic household data to optimize salt and water usage. Many homeowners make the mistake of tossing the
In conclusion, the Nova Water Softener manual provides a comprehensive guide to installing, operating, and maintaining your water softener system. By following these guidelines, you'll be able to enjoy the benefits of soft water and extend the lifespan of your appliances. Remember to regularly check and maintain your system to ensure optimal performance. If you have any further questions or concerns, consult your system's manual or contact a professional for assistance.
The Nova manual stresses: Do not install near water heaters or furnaces. The backflow from a water heater can damage the resin beads. Maintain at least 10 feet of pipe between the softener and the heater. Also, ensure you have a drain within 20 feet, with an air gap (no direct connection to sewer). Solution: Unplug unit for 30 seconds
When an error appears, your Nova Water Softener Manual provides a code list. Here are the most common:
Press and hold the button, then use the UP/DOWN arrows to adjust hardness. Press REGEN to set the backwash time.
Use the UP/DOWN arrows to adjust the hour, minutes, and current date. Press SETTINGS to advance through each field.
Your will have the model number printed on the cover and inside the first few pages. Locate the rating plate on the back of the control valve or on the brine tank lid. Without the correct model, settings like injector size and backwash flow rates will be wrong.