Narco Escort Ii Installation Manual Extra Quality File

Monitor the unit closely upon first activation for any signs of electrical issues or excessive heat.

Requires a "V-dipole" style antenna tuned for 108.00 to 117.95 MHz.

: The unit provides two distinct audio outputs from the rear connector: High-Level Output (Pin 6) Narco Escort Ii Installation Manual

: Unlike older indicators with delicate meter movements, the Escort II uses a gas discharge display

The original was updated by Service Bulletin #ESC-04 (1998). If your manual lacks this supplement, note these corrections: Monitor the unit closely upon first activation for

If you have acquired a second-hand Escort II from a salvage yard or are restoring a classic panel, you are likely searching for the (P/N 930-0178 or similar). You need more than just a PDF—you need a roadmap.

1.0 Last reviewed: October 2025 Document ID: NAR-ESC2-INST If your manual lacks this supplement, note these

| Pin | Function | Wire Color (Typical) | Notes | |-----|-------------------|----------------|--------------------------| | 1 | Power +14V DC | Red | 1.5A breaker | | 2 | Ground | Black | To airframe ground | | 3 | Panel Light (DIM) | Orange | +5V to +28V dimmer bus | | 5 | Encoder Data A1 | Gray | Gray code input | | 6 | Encoder Data A2 | Brown | Gray code input | | 7 | Encoder Data A4 | Yellow | Gray code input | | 8 | Encoder Data A8 | Green | Gray code input | | 9 | Encoder Common | White/Black | Ground reference | | 14 | Antenna coax center | RG-400 | Crimp BNC | | 15 | Antenna shield | RG-400 | Backshell ground | | 31 | Suppression Out | Violet | To DME/KX-170B (if used) | | 32 | Suppression In | Blue | From pulse suppression bus |

The Escort II accepts two formats: (Parallel) or RS-232 (Serial).