Dp Gympac 1500 Assembly Instructions Work

Lay down the two triangular base pieces. Connect them to the primary vertical support frame using set screws.

Once all plates are on, install the top weight plate and secure the top of the guide rods to the frame. 3. Attach the Upper Frame and Pulley System Upper Beam:

The pop-pin spring is weak or the hole is misaligned. Fix: Check that the seat frame is not bent. Apply grease to the pop-pin. If it still slips, replace the pin (part #DP-GP1500-PIN). dp gympac 1500 assembly instructions

The single biggest mistake builders make is rushing to bolt things together. Lay out every part and match it to the inventory list below.

If the cables are frayed or too short, you can fabricate new ones using vinyl-coated cable and threaded terminals. Nick Momrikhttps://nick.blog Modifying/Upgrading a DP Ultra Gympac - Nick Momrik Lay down the two triangular base pieces

Slide the round rubber bumpers (bumpers) onto the guide rods. Add Weights: Slide the weight plates (typically

Insert the weight selector rod into the center hole of the weight plates. Apply grease to the pop-pin

Thread the main cable through the pulley housing at the top support. Pass it through the interior of the tube if necessary.

Attach the top cross beam or upper frame to the vertical support. Use reinforced plates and hex bolts to ensure a rigid connection. Pulley Brackets:

Note: Assembly order may vary slightly depending on the specific revision of your model, but the following sequence is the industry standard for vertical multi-gyms of this era.

You will typically need a set of wrenches (9/16" is common for many DP models), an Allen wrench set, and a rubber mallet for end caps. Step-by-Step Assembly Guide 1. Assemble the Main Base and Frame Start by laying out the base components on the floor. Base Frame: