I was unable to find a dedicated manual for the in my knowledge base or through standard search results. This appears to be a legacy motherboard from Foxconn (Winfast is a brand of Foxconn), likely from the early-to-mid 2000s, possibly using a SiS (Silicon Integrated Systems) chipset.
Wire the front chassis cluster to the group utilizing this layout pin diagram: Power Switch (PW_SW): Connect to pins 6 and 8. Reset Switch (RST): Connect to pins 5 and 7. Power LED (PWR_LED): Map to pins 2 (+) and 4 (-). Hard Drive LED (HDD_LED): Map to pins 1 (+) and 3 (-). BIOS Setup and Diagnostic Configurations Winfast 760m02 Gx 6ls Manual
Note: This board does NOT use +12V for CPU power. Using a standard floppy drive power connector with +12V on pin 1 will destroy the Geode GX1. I was unable to find a dedicated manual
The exact manual is unlikely to be hosted officially anymore. Your best bet is asking in Vogons or Reddit r/retrobattlestations – someone may have the original CD ISO or PDF. If you tell me what specific thing you're trying to do (e.g., connect front panel, find a driver, jumper settings), I can give a more targeted answer. Reset Switch (RST): Connect to pins 5 and 7
Since an official PDF is nearly impossible to locate on Leadtek’s current FTP servers (ftp.leadtek.com.tw), here is a reconstruction of the Table of Contents:
| Pin | DTE Signal | Function | | :--- | :--- | :--- | | 2 | TXD | Transmit | | 3 | RXD | Receive | | 5 | GND | Ground | (Standard RS-232; no need for full handshaking unless Jumper JP3 is set for hardware flow control).