Acurite Professional Weather Center Instruction Manual Model 01536 [new] Site

Once both units are powered on and set to the same ABC channel, the wireless signal icon on the display should begin to flash. Within a few minutes, the bars will turn solid, and the temperature and humidity readings from the outdoor sensor will appear on the screen. If the units do not sync, try moving the sensor closer to the display during the initial pairing process. Step 4: Mounting the 5-in-1 Sensor

The display unit features a "Set" mode to configure the internal clock, date, and units of measurement (Metric or Imperial). Once both units are powered on and set

Height: Mount the sensor at least 5 feet off the ground in an open area. Step 4: Mounting the 5-in-1 Sensor The display

Before starting, verify you have all components: Locate the plastic tab taped into the bottom

| Error/Display | Meaning | Solution | |---------------|---------|----------| | | Sensor reading outside range (-10 to 60°C) | Move sensor away from heat source | | “- -” for wind | No wind data for 30+ minutes | Check battery voltage; spin cups manually | | Rain shows “OL” | Overflow – tipping bucket stuck | Clean rain funnel; remove spider webs | | Battery icon flashes | Low power in outdoor sensor | Replace with lithium AA batteries (best for cold climates) | | Pressure trend arrow stuck | No change in 3 hours | Normal – wait for weather front to pass |

Note: Sensor suite type may vary; most 01536 bundles use the (wind, rain, temp, humidity, UV/light) or 7-in-1 (adds light intensity and UV index).

Locate the plastic tab taped into the bottom of the sensor and remove it. The rain gauge will not record data until this is discarded. images.thdstatic.com 2. Strategic Mounting Guidelines