Packet Tracer 9.3.3 Hsrp Configuration Guide [repack]

You are a junior network engineer at Acme Corp. The company has two core Layer 3 switches (Distribution layer) connecting to a single router acting as the gateway to the internet. Management wants gateway redundancy —if the primary switch fails, users should never notice. The solution? HSRP (Hot Standby Router Protocol) .

Extend HSRP for multiple VLANs (HSRP Groups 1, 2, 3…) or configure tracking to lower priority when an upstream link fails. packet tracer 9.3.3 hsrp configuration guide

By the end of this guide, you will be able to configure Active/Standby router pairs, tune timers, track interfaces, and troubleshoot common HSRP issues—all within Packet Tracer 9.3.3. You are a junior network engineer at Acme Corp

R1(config)# interface gig0/0 R1(config-if)# ip address 192.168.1.1 255.255.255.0 R1(config-if)# no shutdown The solution

Now, enact HSRP. We will use group number 1 and virtual IP 192.168.1.254 .

Router1>enable Router1#configure terminal Router1(config)#interface FastEthernet0/0 Router1(config-if)#ip address 192.168.1.1 255.255.255.0 Router1(config-if)#exit